3     Quick Start-up Guide

3.1     Total Recall 

·        Check the contents of the Total Recall package (refer Section 2.1-Unpacking). Ensure your recording connections are in place.

·         Connect the Total Recall recorder to the input line(s), and connect the power cord.

·         Turn on the power with the switch at the rear panel.

Note: The internal power supply is auto sensing (100VAC-250VAC, 50-60Hz).

·         Wait approximately 2 minutes for Total Recall to complete its start-up.

·        Adjust the contrast of the screen by holding down the  <#> key and pressing the <UP> <DOWN> arrow keys.

·         Default Password is 0000.

·         Go to the Options Menu by pressing the <MENU> key twice.

·         Select General by pressing  <SELECT>.

·         Set Language, Time & Date, Password (if you wish to change the default password).

·         Select Return.

·         Select Line.

·         Set desired “Line” Trigger, “Mon” (Monitor) and “Beep” settings.

·         Select OK to confirm.

·         Select Archive.

·         Set desired Archive settings and then select OK.

·         Press the <MENU> key once and locate the Logging Menu.

·         Use one of the phone lines connected to the recorder and make a test call.

·         Check that the call appears on the Logging Menu, showing “C” in the status column.

·         When finished, enter the password if required, position the cursor over the call and press the <SELECT> button to replay the call. Adjust the speaker volume using the thumb wheel on the front panel.

3.2     Remote Recall 

·         Insert the Remote Recall CD in a multimedia PC, and follow the set-up instructions.

·         If the install did not Auto start choose Start/Run/D:/INSTALLREMOTERECALL.EXE (substitute another CD drive letter if necessary).

·         After installation, the Remote Recall screen will auto-load on the PC. Remove the install CD.

·         Insert an archive CD with calls that have been created on Total Recall.

·         Click the CD icon in the top left corner of the screen. An Options to Customize dialog box will open, listing the archived sessions on the CD. Select All or any number of the sessions and click OK.

·         The window will show the calls loading from the CD, followed by a listing of the call details in the Remote Recall lower window.

·         Find the desired call(s) using the search options.

·         Highlight and double click on any call. A dialog box will appear showing Converting the Call, and then the call will automatically play.