·
Check the contents of the Total Recall
package (refer to Section
3.3-Unpacking). Ensure your recording connections are in place.
·
Connect the Total Recall
recorder to the input line(s), and connect
the power cord.
·
Turn on the power with the switch at the rear panel.
Note 1: The internal power supply
of the desktop is auto sensing
(90VAC-250VAC).
Note 2: The internal power supply of the rack
mount unit is
(110VAC-250VAC).
·
Wait approximately 3 minutes for Total Recall
to complete its start-up.
·
Default Passwords are 0000 (Administrator and User).
·
Go to the Options Menu by pressing the <MENU>
key twice.
·
Select General Settings by pressing <SELECT>.
·
Set Language, Time, Date, Password (if you wish to
change the default password), & Time Zone (call database must be
empty to change the time zone setting), by using the <UP> <DOWN> arrow
keys and <SELECT> to enter the Menu of choice. Press the <OK> or <CANCEL>
key to return to the General Settings Menu.
·
Select Line Settings.
·
Set desired “Line” Trigger, “Mon” (Monitor) and “Beep”
settings by pressing the <DOWN> arrow key to highlight Line 1 and then
pressing <SELECT>.
·
Select Apply to confirm.
·
Press the <OK> or <CANCEL> key to return to the Options
Menu.
·
If you will be connecting the recorder to a network (LAN),
select Network Settings and then set the unique Network Address and
Subnet Mask. Press <OK>.
·
Use one of the phone lines or other audio
sources connected to the
recorder and
make a test call.
·
Check that the call appears on the Logging Menu,
showing “C” in the status column.
·
When the conversation is finished, enter the password if required,
use the arrow buttons to position the
cursor over the call and press the <SELECT> button to replay the
call. Adjust the speaker volume using the thumb wheel on the front panel.
[